Plug And Play; Connecting The Imager With An Rs-232 Serial Port - Wasp 2D Reference Manual

Plug and Play

Plug and Play bar codes provide instant Imager set up for commonly
used interfaces.
NOTE
Connecting the Imager with an RS-
232 Serial Port
NOTE
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the imager.
NOTE
2
4
Product Reference Guide
After you scan one of the codes, power cycle
the host terminal to have the interface in effect.
These instructions are for use with the RS-232
cable. This includes both Power Off the Termi-
nal (P.O.T.) and external power.
For the imager to work properly, you must have
the correct cable for your type of terminal/com-
puter.
3
Plug and Play
1-3