Table of Contents
Advertisement
Output
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar
code below, then set the delay (from 0-30,000 milliseconds) by scanning
digits from the
, then scanning Save.
Programming Chart on page B-5
User-Specified Good Read Delay
Trigger Modes
Manual/Serial Trigger
You can activate the imager either by pressing the trigger, or using a serial
trigger command (see
). When in man-
Trigger Commands on page 11-5
ual trigger mode, the imager scans until a bar code is read, or until the
trigger is released.
When in serial mode, the imager scans until a bar code has been read or
until the deactivate command is sent. In serial mode, the imager can also
be set to turn itself off after a specified time has elapsed (see
Read Time-
, which follows).
Out
* Manual/Serial Trigger
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the imager's trig-
ger when using serial commands to trigger the imager, or if the imager is
in manual trigger mode. Once the imager has timed out, you can acti-
vate the imager either by pressing the trigger or using a serial trigger
command. After scanning the Read Time-Out bar code, set the time-out
duration (from 0-300,000 milliseconds) by scanning digits from the
Pro-
, then scanning Save. Default = 0 (infinite,
gramming Chart on page B-5
or no time-out).
Read Time-Out
3-4
DuraLine™ 2D Imagers
Advertisement
Table of Contents
