Wasp WWS450 Pairing And Installation Instructions

Bluetooth scanner

Butler Manufacturing recommends the Wasp WWS450, which is available

from Barcodes Inc (www.barcodesinc.com) or by phone at 1-800-351-9962.

Note the Battery and Charger is sold separately and required. The Scanner

Cradle is not required.

• Wasp WWS450 scanner Model #633808121464 (Scanner only)

• Model #633808121501 Battery and Charger – sold separately

Table of Contents

Need help?

Do you have a question about the WWS450 and is the answer not in the manual?

Page 1 Bluetooth Scanner – WASP WWS450 Pairing and Setup Butler Manufacturing recommends the Wasp WWS450, which is available from Barcodes Inc (www.barcodesinc.com) or by phone at 1-800-351-9962. Note the Battery and Charger is sold separately and required. The Scanner Cradle is not required.
Page 2 Bluetooth Scanner – WASP WWS450 Pairing and Setup 1) Scan. Note: this may take few seconds for the scanner to rest. The Scanner will beep. 2) Scan 3) From your device start the Bluetooth pairing process by selecting the scanner from your available Bluetooth devices.
Page 3 Bluetooth Scanner – WASP WWS450 Pairing and Setup Once paired, scan the barcode to the right. You will hear several beeps. Scan each in order Single Beep Single Beep Single Beep Two Beeps You will hear several beeps, followed by a long beep.