General Safety Instructions - Pylontech Force-H3 Operation Manual

1.3 General Safety Instructions

Danger: Batteries deliver electric power, resulting in burns or a fire hazard when they are
short circuited, or wrongly installed.
Danger: Lethal voltages are present in the battery terminals and cables. Severe injuries or
death may occur if you touch the cables and terminals.
Warning: DO NOT open or deform the battery module, otherwise the product will be out
of warranty scope.
Warning: Whenever working on the battery, wear suitable personal protective equipment
(PPE) such as rubber gloves, rubber boots and goggles.
Warning: Force-H3 system working temperature range:-10℃~55℃; Optimum
temperature: 18℃~28℃. Out of the working temperature range may cause the battery
system over / low temperature alarm or protection which will further lead to the cycle life
reduction. It will affect the warranty terms as well.
Warning: For battery installation, the installer shall refer to NFPA70 or similar local
installation standard for operation.
Caution: Improper settings or maintenance can permanently damage the battery.
Caution: Incorrect inverter parameters will lead to a further faulty/damage to battery.
Reminding
1. It is very important and necessary to read the user manual carefully before installing or using
the battery. Failure to do so or to follow any of the instructions or warnings in this document
can result in electrical shock, serious injury, death, or can damage battery, potentially
rendering it inoperable.
2. If the battery is stored for long time, it is required to charge them every six months, and the
SOC should be no less than 90%.
3. Battery needs to be recharged within 12 hours, after fully discharged.
4. Do not expose cable outside.
5