Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
– Unscrew screws -2- and remove speaker -1-.
– Release connector and pull it off.
Installing
Installation is carried out in the reverse order.
Specified torques
Component
Fixing screws for speakers
11.5.2
Removing and installing speaker for
emergency call module - R335- , vehi‐
cles for EU countries except Russia and
Belarus
Removing
– Remove the cover below the dash panel on front passenger
side.
– Unscrew the screws -arrows- and remove the speaker -1-.
– Disconnect plug connection -2-.
Installing
Installation is carried out in the reverse order.
Specified torques
Component
Fixing screws for speakers
11.6
Removing and installing GSM aerial 2 -
R267-
The aerial is attached to the air distributor with double-sided ad‐
hesive tape (see Fig.)
Removing
– Switch off the ignition and all electrical components.
– Remove the display unit for control unit of the display and op‐
erating unit, front information - J685-
⇒ "1.3.2 Removing and installing the display unit for control
unit of the display and operating unit, front information J685 ,
Bolero, Amundsen and Columbus ", page 11
58
Rep. gr.91 - Communication
Tightening torque
1.5 Nm
Tightening torque
1.5 Nm
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.