Skoda Octavia III 2013 Workshop Manual page 42

Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
– Position the paddles on both wheel centre supports - VAS
6350/1- and attach them with clamping bolts.
– Place the wheel centre support - VAS 6350/1- on the wheel
bolts of the rear axle.
The wheel centre supports - VAS 6350/1- are then positioned and
held in place in the adapters by the "O-rings".
Note
Place the wheel centre support - VAS 6350/1- on the wheels so
that any "anti-theft wheel bolts" are not connected to the wheel
centre support - VAS 6350/1- .
– Adjust the paddles using the clamping bolts so that they can
move freely just above the ground. Ensure that the paddles
can move freely.
– Fit and set up the calibration device - VAS 6350- .
⇒ "7.4.1 Fitting and setting the calibration device VAS 6350 /
VAS 6350A ", page 35
Measuring the distance:
– Switch on the distance laser - VAS 6350/2- .
The following screen is displayed:
Press the applicable button (depending on type of measuring de‐
vice) to set up measurement from the bottom edge of the distance
laser, see Pos. -2-:
1 - Screen when measuring from the top edge of the distance
laser
2 - Screen when measuring from the bottom edge of the dis‐
tance laser
38
Rep. gr.91 - Communication
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.