Skoda Octavia III 2013 Workshop Manual page 17

– Pull on the release tools -arrows- to remove the control unit
-1-.
– Compress plug catch -arrows-.
– Open catch clamp -arrow- and disconnect plug.
– Release and pull off other plug connections.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Vehicles manufactured up to CW 13/2013:
Caution
After sliding the unit into the assembly opening, you must al‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
ways secure the wiring harness with cable strap back to the rib
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
of the heating and air conditioning unit.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
If the wiring harness is incorrectly installed, there is a risk that
the harness will collide with the recirculation flap for the heating
and air conditioning unit.
– Perform visual inspection to ensure recirculation flap is func‐
tioning after installing.
All vehicles:
For replacing the pairing of the Infotainment display and control
unit, see ⇒ "1.1 Installation – Infotainment system", page 4
Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
.
13
1. Infotainment system