Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
– Unscrew the screw, arrow -A-, then swivel out and remove the
switch unit for gearbox operation -1- in direction of arrow -B-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Before the airbag is installed, it must be checked if all the wiring
♦
is properly pressed back into the guiding grooves in the steer‐
ing wheel foam. Wiring which protrudes can be damaged by
the backside parts of the airbag.
When tightening the screw -A- keep the button -1- in the right
♦
position (edge of the button -1- on a line with the edge of the
steering wheel).
Follow the work procedure to connect the battery ⇒ Electrical
♦
system; Rep. gr. 27 ; Battery; Disconnecting and connecting
the battery .
♦
Connect the ⇒ Vehicle diagnostic tester and query event mem‐
ory, delete if required.
Specified torques
Component
Mounting screw for switch unit
44
Rep. gr.91 - Communication
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Tightening torque
1.7 Nm