Skoda Octavia III 2013 Workshop Manual page 54

Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
Note
If no PIN code (password) is available, then switch off the ig‐
♦
nition and, if necessary, disconnect the battery earth strap or
the connector on the SmartGate unit for approx. 30 seconds.
After re-connecting the battery earth strap, switch on the igni‐
♦
tion and enter the vehicle identification number (in uppercase)
as the PIN code.
Up to four communications devices can be connected to the
♦
SmartGate system at the same time.
Connection problems
If the connection fails, then check the following points:
♦ Are the conditions for a successful connection fulfilled?
♦ Does SmartGate show up in the list of available WLAN net‐
works?
♦ Was password required for validating the connection entered
correctly?
♦ Is the communications equipment to be connected possibly
still connected to another WLAN network?
If the above mentioned points are okay, and the connection still
fails, then check the state of the LED display on the control unit
for information electronics 2 - J829- (SmartGate) located under
the driver's seat.
If the LED display -arrow- on the control unit:
♦ is unlit or lit red, the device is not OK, check the electrical wiring
as per ⇒ Current flow diagrams, Electrical fault finding and
Fitting locations; if needed, replace the SmartGate control unit
♦ red flashing - this is a self-test, wait for the test to complete (on
initial activation)
♦ lit green – the device is OK, no user is connected
♦ green flashing - the device is OK, at least one user is connec‐
ted and the SmartGate application is active on the connected
communication device (if you connect without an active appli‐
cation - the LED display is lit green)
♦ flashing red and green - the device is OK; and still in production
mode (indicates production mode, for example in Production,
where multiple vehicles with SmartGate exist at one location)
♦ orange (red and green at the same time) – the device is in
upgrade mode, wait for this mode to complete
Disconnecting
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
The connection to SmartGate can be disconnected in one of the
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
following ways:
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
♦ by disconnecting the connection to SmartGate on the connec‐
ted communications device
♦ by disabling WLAN on the connected communications device
♦ by switching off the ignition and removing the ignition key for
more than 5 s (for vehicles with an ignition starter switch, by
switching off the ignition and opening the driver door)
50
Rep. gr.91 - Communication