Skoda Octavia III 2013 Workshop Manual page 34

Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
Removing and installing luggage compartment side trim pan‐
el .
– Remove screws -arrows-.
Octavia
Octavia Combi
– Disconnect plug and remove amplifier -1-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Specified torques
Component
Fixing screws for the aerial signal
amplifier
5.4 Removing and installing storage com‐
partment with interface for mobile tele‐
phone - R265-
Note
From CW 22/2016, also for charging mobiles without wires (see
⇒ "3.1 Structure - Antenna systems", page 19
– Remove storage compartment in the front centre console ⇒
General body repairs, interior; Rep. gr. 68 ; Centre console .
– Release connector and pull it off.
– Release induction plate -1- from the latches -arrows- and take
out of the storage compartment -2-.
– Installation is carried out in the reverse order.
30
Rep. gr.91 - Communication
Tightening torque
5 Nm
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
).