Skoda Octavia III 2013 Workshop Manual page 40

Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
♦ There is no one in the vehicle.
♦ Vehicle is unladen (unladen weight).
♦ Before each calibration: switch on ignition.
Overview of attached calibration device - VAS 6350- / -VAS
6350A-
1 - Škoda badge, middle of ve‐
hicle
2 - Wheel centre support - VAS
6350/1- / -VAS 6350/1A-
3 - Right angle
❑ Support for the distance
laser - VAS 6350/2-
4 - Distance laser - VAS
6350/2- / -VAS 6350/2A-
❑ Instructions for operat‐
ing ⇒ Owner's manual
5 - Linear laser - VAS 6350/3- /
-VAS 6350/3A-
❑ On the calibration plate
❑ Switching on and off ⇒
Owner's manual
6 - Plastic food
❑ Three on bottom of the
calibration plate
❑ Adjustable to change
the horizontal position of
the calibration plate
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
7 - Calibration plate
❑ position behind vehicle -
the dimension -a- (1400
mm to 2000 mm) must
be identical on both
sides
8 - Spirit level
❑ On the calibration plate
❑ To check the horizontal
position
9 - Left angle
❑ Support for the distance laser - VAS 6350/2- / -VAS 6350/2A-
10 - Wheel centre support - VAS 6350/1- / -VAS 6350/1A-
Aligning the calibration plate
– Position the calibration plate behind the vehicle with clearance
of 1400mm to 2000mm (the clearance must be identical on
both sides – see dimension -a- in the overview figure).
– Bring the calibration device - VAS 6350- to a horizontal posi‐
tion.
36
Rep. gr.91 - Communication
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.