Skoda Octavia III 2013 Workshop Manual page 15

– Open catch clamp -arrow- and disconnect plug.
– Release and pull off other plug connections.
– Press back catches from the side and remove the unlocking
tools.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
When inserting the display and control unit, on no account press
on the display or on the operating buttons, otherwise they will be
damaged.
For replacing the pairing of the Infotainment display and control
unit, see ⇒ "1.1 Installation – Infotainment system", page 4
1.3.2 Removing and installing the display unit
for control unit of the display and oper‐
ating unit, front information - J685- , "Bo‐
lero", "Amundsen" and "Columbus"
Special tools and workshop equipment required
♦ Release tool - T10057-
Removing
– Switch off the ignition and all electrical components.
Vehicles manufactured up to CW 05.2017:
– Insert unlocking tools - T10057- into the openings in the dis‐
play unit -see fig.- until there is an audible click.
– Pull on the unlocking tools -arrows- to remove the display unit.
Vehicles manufactured as of CW 06/2017:
– Use the disassembly wedge to prise off the strip -2- from below
(arrows -A-) in direction of arrow -B- and to remove it in direc‐
tion of arrow -C- from the unit -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
.
11
1. Infotainment system