Skoda Octavia III 2013 Workshop Manual page 65

Hide thumbs Also See for Octavia III 2013:
Table of Contents

Advertisement

– In
Targeted fault finding
erating mode for the control unit for emergency call module
and communication unit - J949- , select the
⇒ Vehicle diagnostic tester.
– Exit
Targeted fault-finding
– Remove ignition key (for vehicles with interface for entry and
start system, switch off ignition and open the driver's door for
at least 5 seconds).
– Disconnect ⇒ Vehicle diagnostic tester.
– Drive vehicle out of workshop so that the vehicle has GPS and
GSM reception.
– Switch on the ignition and leave switched on for at least 10
minutes, but do not connect the vehicle diagnosis tester .
The status LED -1- is lit red after ignition is switched on.
When successfully activated after the communication profile has
been downloaded, the colour of the status LED -1- changes from
red to green as you wait.
– Checking the functions of the Škoda Connect services (see ⇒
Owner's Manual Octavia III ). If they are not active, restart the
infotainment unit (press the switch-on button/virtual switch-on
button on the display unit for approx. 15 seconds until the in‐
fotainment unit restarts).
If the status LED is still red even after 10 minutes since ignition
was switched on:
Connect the ⇒ Vehicle diagnostic tester (address 0075 - read
measured values) and then read the following blocks:
♦ Network Connectivity
♦ GSM signal strength
♦ GPS signal strength
If the measured values are OK and the status LED:
♦ is red
♦ is green and the control unit for emergency call module and
communication unit - J949- is not communicating or the Škoda
Connect services are not available (see ⇒ Owner's Manual
Octavia III )
– Create a DISS ticket (a technical repair request, DISS mes‐
sage) and send it to the Technical Service Centre (TSC).
11.8.2
Replacing, adapting and activating con‐
trol unit for emergency call module and
communication unit - J949- , vehicles for
Russia and Belarus
Data for "targeted fault-finding" in ⇒ Vehicle diagnostic tester
current
Procedure when replacing:
– In
Targeted fault finding
erating mode for the control unit for emergency call module
and communication unit - J949- , select the
function (address 0075) ⇒ Vehicle diagnostic tester.
place
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
– Follow the instructions on the ⇒ Vehicle diagnostic tester (in‐
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
cludes the steps: coding, parameterisation, adaptation to im‐
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
mobiliser).
or
Targeted functions
function
Activate
or
Targeted functions
or
Targeted functions
Transfer/re-
Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
op‐
.
op‐
11. Mobile services online
61

Advertisement

Table of Contents
loading

This manual is also suitable for:

Octavia iii 2014

Table of Contents