Skoda Octavia III 2013 Workshop Manual page 57

During the entire upgrade process, make sure that the ignition is
on, or the engine is running (avoid starting the engine during the
upgrade procedure).
Update procedure:
– Download the update data for SmartGate from the ŠKODA
website; save them on the communications device (one file).
– Switch on WLAN on the communications device.
– Switch on the ignition and start the engine.
– Connect the communications device with SmartGate.
– Open the web browser on the communications device, and
enter the address "HTTP://192.168.123.1/index.html".
– At the bottom of the SmartGate menu that appears, select the
firmware upgrade menu item.
– Select the update data stored on the communications device.
– Pressing "start update" copies the update data to SmartGate
(copying takes about 5 min).
– After downloading the data and confirming "perform update",
the update starts (the update process takes approx. 2 min).
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– After completing firmware update, the SmartGate is restarted.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Note
During the update process, the LED display on the control unit
♦
for information electronics 2 - -J829-- lights up orange (red and
green at the same time).
♦ After completing the update and restarting the SmartGate, the
LED display lights up/flashes green, see
Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
⇒ page 50 .
53
10. SmartGate system