Installing and Connecting a Redundant Power System
.
Figure 2-9
1
Redundant power supply connector
Figure 2-10
1
A4 switch
2
RPS cable (1 meter long)
3
STK-RPS-150PS redundant power supply
connector
4.
If the switch itself is not plugged into power, the front panel RPS LED indicator will show that
a redundant power supply is now in operation.
.
This completes the installation.
2-16 Installation
Note: No change in switch configuration is necessary for this installation.
Power Connectors on STK-RPS-150PS (rear view)
STK-RPS-150PS RPS Cable and AC Power Cord Connections
Note: No change in switch device configuration is necessary for this installation.
2
AC power connector
4
A4 switch redundant power supply connector
5
AC power cord (type varies depending on country)
6
AC power outlet with ground connection
(type varies depending on country)