Cpu Led In Virtual Switch Bonding (Vsb) Configuration - Enterasys S Series Hardware Installation Manual

LEDs
Table 3-2 System LEDs (continued)
LED Color
Blue
PWR Off
Green
Amber
\
Table 3-3
configuration.
Figure 3-4
Color
Green and Blue
Blue
Blue
3-4 Troubleshooting
State
Blinking. Virtual Switch Bonding is enabled, but the
devices are not bonded
Solid. Virtual Switch Bonding is enabled, and the
devices are bonded.
The SSA switch is not receiving power from the
power supplies.
Functional. Indicates one of the following conditions:
• A single power supply is present and operating
normally.
• Two power supplies are present and operating
normally.
One of the following conditions has occurred:
• Two power supplies are present but only one is
operating normally while the other is not
connected.
• Two power supplies are present but only one is
operating normally while the other indicates a
fault.
• Both power supplies are faulty but the SSA switch
is still receiving power.
• Power supplies are operating in additive (non-
redundant) mode.
• Other internal fault.
Note: The PWR LED status indication is based on power supplies being powered on.
describes the CPU LED when the SSA switch is in a virtual switch bonding

CPU LED in Virtual Switch Bonding (VSB) Configuration

Recommended Action
None.
None.
Ensure the power cords are plugged in
and power is available at the source.
Contact Enterasys Networks for technical
support.
None.
Ensure the power cords are plugged in
and power is available at the source.
Contact Enterasys Networks for technical
support.
State
Blinking. Image has started and found chassis bonding enabled.
Solid. Functional (binding is operational and ready to switch)
Blinking. Binding is not functional (non-operational).