Advertisement
To automatically set bus ID numbers:
•
Hold the switch on the BIM-01-2-FTCH case while turning the key on. The BIM display will show the current
revision code while this is held.
•
Press and release the switch until the display shows (auto channel).
•
Press and hold to enter this menu. When you see on the display, release the switch.
•
The display will display , , then as the BIM automatically determines the best ID to assign for the boost
option (if enabled).
•
The display will show . Press and hold the switch to exit setup or press and release to choose another menu
option.
Enabling Gear Position:
•
Hold the switch on the BIM-01-2-FTCH case while turning the key on. The BIM display will show the current
revision code while this is held.
•
Press and release the switch until the display shows (gear position).
•
Press and hold to enter this menu. When you see on the display, release the switch.
•
The display will show the current gear position state, (disable) or (enable).
•
Tap the switch to change the state.
•
To save the setting press and hold the switch until you see on the display, then release the switch.
•
The display will display the next available menu. Press and hold the switch to enter that menu or tap the switch to
select another menu.
•
To exit, tap the switch until the display shows then press and hold the switch until you see on the display.
Quick tips:
While the BIM is operating, the dot in the upper left corner of the display will indicate the status:
•
On steady indicates it is powered up but not receiving any BIM bus activity.
•
Flashing indicates it is communicating on the BIM bus.
•
A dot in the upper center indicates that there is an engine code set (MIL active).
•
If the display shows "BUS", then it is scanning to try and communicate with the vehicle bus but cannot get an
answer.
o
This could indicate that the FiTech CAN outputs have not been enabled (pg. 7), or that the BIM-01-2-
FTCH is not compatible with this ECU.
To see the sensor and channel status on the BIM display, press and hold the switch to cycle through the screens.
The first screen will show the bus type ( - FiTech), and the following screens will display the data that is available:
"" – Engine Coolant Temp
"" - Intake Air Temp
"" - Gear Position
"" - Boost/Vacuum data
"" - RPM/Tachometer data
If you do not see any number of these listed, the data may not be transmitted for the BIM-01-2-FTCH to read.
Emissions note:
If your vehicle requires emissions testing in your area, the check engine feature of this unit cannot be used to operate the
Check Engine or Service Engine indicator.
[9]
MAN #650819A
Advertisement
