Dakota Digital BIM-22-2 Quick Start Manual

This guide is designed to get you up and running quickly with the BIM-22-2 on an HDX system. It provides a
brief installation explanation as well as a step-by-step Locate procedure for finding the sensors' positions
after a tire rotation has taken place.
This BIM-22-2 communicates with a TPMS Receiver Module which receives tire pressures and other information from
four TPMS pressure sensors installed in a vehicle's tires. It then provides this information for displaying on an HDX
instrument system.

Do not mount the BIM-22-2 and TPMS Receiver modules in the engine compartment; they should be mounted
in the interior of the vehicle. In situations where TPMS reception is not adequate inside the interior of the
vehicle, the weatherproof TPMS Receiver Module can be mounted outside on the chassis near the center of
the vehicle for better reception of the RF transmission signals from the TPMS sensors.

The BIM-22-2 should be installed in a location where its display and switch are accessible in the event a
TPMS Sensor needs to be replaced (See BIM Learn Sensors Mode in the section Special Operating Modes of
the BIM-22-2 owner's manual).

Connect the BIM-22-2 to the HDX control box using the BIM-xx-2 18 inch power/data harness.

Connect the BIM-22-2 to the TPMS Receiver Module using the TPMS Receiver Module adapter Harness.

Install the TPMS sensors in the vehicle's tires to the locations indicated by their marked colors (LF = Red, RF
= Green, LR = Blue, RR = Yellow).
HDX QUICK START GUIDE FOR
BIM-22-2 - TPMS
(Tire Pressure Monitoring System)
MAN#650600