Advertisement
BIM setup:
BIM menu table:
Menu
Options
Enable CAN Outputs using the FiTech handheld
(Required for operation, and if the vehicle battery is disconnected or the FiTech ECU firmware is updated)
•
Connect the FiTech handheld to the ECU using the provided CAN-bus adapter harness.
•
Enter the "FiTech Initial Setup" menu:
o
•
Enter the "CAN OUTPUT" menu:
o
•
For each CAN output, change the "val" field to On, then press the "Send to ECU" button to turn the output on.
o
NOTE: The "Send to ECU" button will only enable the currently highlighted CAN output. This step must
o
be repeated for every CAN output that you wish to enable.
o
If the CAN output for a respective reading is not enabled, the BIM-01-2-FTCH will not receive these
readings from the FiTech bus.
Default
Enable air fuel ratio reading
Enable boost reading
Check engine light sent by ECU
View the current BIM ID numbers
Automatically set bus ID numbers
Enable gear position reading
Exit Setup
Notes
[7]
MAN #650819A
Advertisement
