Dakota Digital BIM-01-2-FTCH Manual page 3

VFD3 Setup Continued:
Obtaining RPM from the BIM-01-2-FTCH
•
Hold the SW1 switch from the instrument system control box while turning the key on.
The speed display should show  and the message display should show SETUP.
o
•
Release SW1. Tap SW1 until  and TACH are displayed.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The displays should show  and T CAL.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The speed display will show the current
setting.
•
Tap SW1 until and BUS are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
•
Tap SW1 until  and DONE are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
Obtaining engine temperature from the BIM-01-2-FTCH
•
Hold the SW1 switch from the instrument system control box while turning the key on.
The speed display should show  and the message display should show SETUP.
o
•
Release SW1. Tap SW1 until  and WATER are displayed.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The displays should show  and SENDER.
•
Press and hold SW1 for at least 3 seconds, until  changes to "-". The speed display will show the current
setting.
•
Tap SW1 until  and BUS F (Fahrenheit) is displayed.
Tap SW1 once more for  and BUS C (Celsius) if desired.
o
•
Press and hold SW1 until "-" and DONE are displayed.
•
Tap SW1 until  and DONE are displayed.
•
Press and hold SW1 until "-" and DONE are displayed.
***Intake/manifold air temp, air fuel ratio, trans fluid temp, and boost will be displayed in the message center if activated through the display menu setup.
[3] MAN #650819A