Preparing The System - Sun Microsystems Ultra 80 Installation Manual

Preparing the System

1. Lay the system on its side.
Facing the back of the system, tip the unit to the left so the feet are to the right.
Note – Place the system on the power supply side. Do not place the system on the
access panel side.
2. Remove the three screws from the base of the power supply at the back of the
system. Set the screws aside (
Access panel
Power
supply
Removing the Power Supply Screws
FIGURE 8
).
FIGURE 8
Sun Ultra 80 Rack Mount Installation Guide
System feet
15