Table of Contents
Advertisement
I. Introduction
A. Important Information
The following terms are used throughout this
manual to bring attention to the presence of hazards
of various risk levels, or to important information
concerning product life. It is critical that all personnel
read and follow all the information provided in the
boxes marked DANGER, WARNING, CAUTION, and
NOTICE.
DANGER
Indicates an imminent hazardous situation which,
if not avoided, will result in death, serious injury or
substantial property damage.
WARNING
WARNING
Indicates a potentially hazardous situation which, if
not avoided, could result in death, serious injury, or
substantial property damage.
CAUTION
Indicates a potentially hazardous situation which, if
not avoided, may result in moderate or minor injury,
or property damage.
NOTICE
NOTICE
Indicates special instructions on installation,
operation, or maintenance which are important but
not related to personal injury hazards.
Thermal Solutions, 1175 Manheim Pike, Lancaster, PA 17601 Website: www.thermalsolutions.com
DANGER
CAUTION
Phone: 717-239-7642 Fax: 877-501-5212 Email: sales@thermalsolutions.com
B. Disclaimers and Local Codes
Installation must conform to the requirements of
the authority having jurisdiction. In the absence of
such requirements, installation must conform to the
National Fuel Gas Code, NFPA 54/ANSI Z223.1, and/
or CAN/CGA B149 Installation Codes. Where required
by the authority having jurisdiction, the installation
must conform to the Standard for Controls and Safety
Devices for Automatically Fired Boilers, ANSI/ ASME
CSD-1.
Installation, start-up, and maintenance of this
equipment can be hazardous and requires trained,
qualified installers and service personnel. Do not
install, operate, service or repair any components
of this equipment unless you are qualified and fully
understand all requirements and procedures. Trained
personnel refer to those who have completed Thermal
Solutions Service School training specific to this
product.
The boiler heat exchanger is manufactured and
stamped in accordance with ASME Boiler and Pressure
Vessel Code, Section IV for a maximum allowable
working pressure and operating temperature of 160
psig (1103 kPa) and 210 F(99 C) respectively. Aqua-stat
is factory set at 200 F (93 C).
NOTICE
NOTICE
Post these instructions and maintain in legible
condition.
5
Advertisement
Table of Contents
