Table of Contents
Advertisement
Arctic Installation and Operation Manual
1
Introduction
1.1
Important Information
The following terms are used throughout this
manual to bring attention to the presence of
hazards of various risk levels, or to important
information concerning product life. It is
critical that all personnel read and follow all
the information provided in the boxes marked
DANGER, WARNING, CAUTION, and
NOTICE.
DANGER
Indicates
an
imminently
situation, which, if not avoided, will result
in death, serious injury or substantial
.
property damage
WARNING
Indicates
a
potentially
situation, which, if not avoided, could
result
in
death,
substantial property damage.
CAUTION
Indicates
a
potentially
situation, which, if not avoided, may result
in moderate or minor injury or property
damage.
NOTICE
Indicates
specific
installation, operation, or maintenance,
which are important but not related to
personal injury hazards.
Thermal Solutions, 1175 Manheim Pike, Lancaster, PA 17601 Web:
Phone: 717-239-7642 Fax: 877-501-5212 Email:
6
hazardous
hazardous
serious
injury
or
hazardous
instructions
on
1.2
Disclaimers and Local Codes
Installation must conform to the requirements
of the authority having jurisdiction. In the
absence of such requirements, installation
must conform to the National Fuel Gas Code,
NFPA
54/ANSI
CAN/CGA B149 Installation Codes. Where
required by the authority having jurisdiction,
the installation must conform to the Standard
for Controls and Safety Devices for Automatically
Fired Boilers, ANSI/ ASME CSD-1.
Installation, start-up, and maintenance of this
equipment can be hazardous and requires
trained,
qualified
installers
personnel. Do not install, operate, service or
repair any components of this equipment
unless you are qualified and fully understand
all requirements and procedures. Trained
personnel refer to those who have completed
Thermal Solutions Service School training
specific to this product.
The boiler heat exchanger is manufactured
and stamped in accordance with ASME Boiler
and Pressure Vessel Code, Section IV for a
maximum allowable working pressure and
operating temperature of 160 psig (1103 kPa)
and 210 F(99 C) respectively. Aqua-stat is
factory set at 200 F (93 C).
NOTICE
Post these instructions and maintain in
legible condition.
www.thermalsolutions.com
sales@thermalsolutions.com
Form: 2435
Revision: 8
Date: 9-19-2016
Z223.1,
and/
or
and
service
Advertisement
Table of Contents
