Table of Contents
Advertisement
5. Press top cap down into the holes at the top of the tower frame.
6. Select the appropriate language from the multilingual label sheet. Remove backing from multilingual label and apply to the left
and right slots in the front cap.
Install Pads
1. Install screws and washers securing the seat pad to the main frame assembly using an 8mm Allen wrench.
2. Install hole plug to the main frame assembly using a rubber mallet.
3. Install screws and washers securing the lumbar pad to the main frame assembly using an 8mm Allen wrench.
Test Unit For Proper Operation
Item
1
Multilingual Label with General Warning
2
Item
1
2
3
4
Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).
Item
1
2
3
Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).
Page 28 of 38
Description
Front Cap
Description
Seat Pad
Screw, M10 x 1.5, 35mm
Washer, Flat 3/8"
Hole Plug, 1"
Description
Lumbar Pad
Screw, M10 x 1.5, 35mm
Washer, Flat 3/8"
Qty.
1
1
Qty.
1
3
3
1
Qty.
1
6
6
Advertisement
Table of Contents
