Table of Contents
Advertisement
2. Slide increment weight guide rods through the top of the tower frame and down through the clips in the increment weight. Place
increment weight guide rods into holes at the bottom plate of the tower frame.
3. Thread increment weight guide rods into the bottom plate of the tower frame. Tighten using a crescent wrench.
4. Install nuts and washers securing the increment weight guide rods to the top plate of the tower frame using a 7/16" wrench.
Item
1
2
Item
1
Item
1
2
3
Tighten hardware to 16-20 in-lb (1.8-2.2 Nm).
Page 13 of 38
Description
Increment Weight Guide Rod
Increment Weight
Description
Increment Weight Guide Rod
Description
Nut, ¼" Nylock
Washer, Flat ¼" ID
Increment Weight Guide Rod
Qty.
2
1
Qty.
2
Qty.
2
2
2
Advertisement
Table of Contents
