Table of Contents
Advertisement
16. Thread cable end through the jam nut and into the head plate bayonet. See
NOTE: Check proper thread engagement. To do so, attempt to pass a 7mm Allen wrench through the portal in the head plate
bayonet. If it goes through, more threads are needed to meet the minimum requirement.
Correct Depth: Thread engagement exceeds minimum depth.
17. Select either the LBS or KG weight stack label. Remove backing from label and apply to weight stack.
NOTE: One weight stack label sheet, LBS or KG, is used for both weight stacks.
18. Test the tower assembly.
19. Route cable out through hole at the bottom of tower side tube. Route cable through the lower pulley assembly.
Cable Handling Guide
Item
1
2
3
Incorrect Depth: Thread engagement not deep enough.
Item
1
2
Page 18 of 38
for details.
Description
Cable
Nut, M16 Hex Jam
Head Plate Bayonet
Description
Weight Stack Label
Weight Stack
Qty.
1
1
1
Qty.
1
1
Advertisement
Table of Contents
