Table of Contents
Advertisement
Install/Remove Optional Shims
The objective of installing/removing shims is to get the detent arm assembly as close to vertical as possible, to remove play between
the input arm assembly with pulleys and detent arm assembly, and to remove play between the input arm assembly and detent arm
assembly.
1. To bring the input arm assembly with pulleys and detent arm assembly closer or bring the detent arm assembly towards the front
of the machine:
a. Lean the input arm assembly with pulleys towards the rear of the machine.
b. Remove screws and washers securing the bumper to the base frame assembly using a Torx screwdriver.
c. Remove shim from under the front bumper.
2. To increase the gap between the input arm assembly with pulleys and detent arm assembly or bring the detent arm assembly
towards the rear of the machine:
a. Install additional shim under the front bumper.
Item
1
2
3
Item
1
2
Page 25 of 38
Description
Screw, 10-32, TRX
Washer, M6
Bumper
Description
Shim
Bumper
Qty.
4
4
1
Qty.
TBD
1
Advertisement
Table of Contents
