Driver And Firmware Installation Steps - Telestream Lightspeed Live Capture User Manual

Note: Log into the
Capture installer before proceeding with these tasks to update Live Capture.
All of the required files for each release are in the Installer folder, located in their
respective folders:
•
AJA Drivers and Firmware
•
Live Capture Installer
•
Nvidia
•
USB-Serial Drivers
•
Vantage Updates

Driver and Firmware Installation Steps

If a new version of the NVIDIA Graphics and GPU driver is required:
1. Uninstall the NVIDIA Graphics Driver using the Windows Apps & Features Control
Panel.
2. Install the driver appropriate for your Lightspeed Live system using the installer in
the Installers\Nvidia\ folder. Using the Advanced options > Clean Install is
recommended.
3. After updating the NVIDIA driver, be sure to reset your GPU to operate in TCC mode
(see
If a new version of the AJA driver for Corvid-based SDI capture is required:
1. Uninstall AJA NT2V Drivers from Windows Apps & Features Control Panel
2. Install new AJA driver from the installer located in the Installers\AJA Drivers and
Firmware\Driver\ folder.
If a new version of AJA firmware is required:
1. Open cmd.exe and change the directory to Installers\AJA Drivers and
Firmware\Firmware\.
2. Identify the BIT (~.bit) file appropriate for your Corvid hardware.
3. On a single Corvid card system run
[corvid_xxx.bit]
4. For a system with multiple Corvid cards, direct the target of the update with the -d
argument. For example:
ntv2firmwareinstaller -d0 [corvid_xxx.bit]
ntv2firmwareinstaller -d1 [corvid_xxx.bit]
5. Power down the system and restart it, to enable the system to initialize the cards
with the new firmware.
Lightspeed Live Capture User Guide
Telestream Live Capture Support Portal
Setting Your NVIDIA GPU to TCC
where
Configuring Vantage and Updating Live Capture
Mode).
ntv2firmwareinstaller -p
is the version number.
xxx
Updating Live Capture Software
and download the Live
93