Capturing Tape Media
172
Using the Tape Capture Web App
Using the Tape Capture Web App
This topic explains how to perform typical tasks using the Tape Capture web
application, and presents them in the order you usually follow to capture clips. The
display indicator state for on/off controls is:
•
•
Setting up for Clip Logging
Before you begin logging and capturing, you must make preliminary selections:
1.
2.
3. Configure capturing using the steps in the next topics.
Creating and Naming Tapes
Before you begin logging clips you want to capture, you should create tapes in the Tape
Capture web app to match the tapes you plan to use in the VTR to capture clips:
1. In the Tapes panel, click the + (plus) button.
2. Enter tape information and press Enter.
3. Repeat to create as many tapes as needed for the clips you plan to capture.
The tape name is embedded in the output of the QuickTime and QuickTime Open
container (and Avid MXF OP-Atom when generated by an Avid workflow via the Flip/
Flip64 action) and is viewable in these applications: Final Cut Pro, Adobe Premiere Pro,
and DaVinci Resolve.
In DaVinci Resolve, the Assist Using Reel Names... setting must be changed for the Tape
Reel Name to display. Go to File > Project Settings > General Options and enable Assist
Using Reel Names and set it to Embedding in Source Clip File.
To disable the propagation of the tape reel name, in the Tape action of the target
workflow, check Disable Tape Reel Name.
Enabled
Disabled
Select a channel Group and VTR source in the upper left corner.
Select Workflows and then select a specific workflow from the list.
Lightspeed Live Capture User Guide
Need help?
Do you have a question about the Lightspeed Live Capture and is the answer not in the manual?