L L I I G G H H T T H H O O U U S S I I N N G G
1. Bulb
4. Apply dielectric grease to the new bulb contacts.
5. Insert the new bulb so that the filament is horizontal.
6. Press the bulb holder into the housing and rotate it clockwise one
quarter turn.
7. Reconnect the lights to the harness.
8. Always check light operation after replacement. If the lights do not
operate, see your authorized Can-Am Off-road dealer for service.
9.
T T a a i i l l l l i i g g h h t t / / B B r r a a k k e e L L i i g g h h t t
In the unlike event they do not work, have them checked by an author-
ized Can-Am Off-road dealer, repair shop or person of your choosing.
LED lights can not be replaced. In case of a malfunction, the tail light /
brake light unit must be replaced.
D D r r i i v v e e C C h h a a i i n n , , R R o o l l l l e e r r a a n n d d S S p p r r o o c c k k e e t t s s
I I n n s s p p e e c c t t i i n n g g t t h h e e D D r r i i v v e e C C h h a a i i n n a a n n d d t t h h e e S S p p r r o o c c k k e e t t s s
R R e e p p l l a a c c e e c c h h a a i i n n a a n n d d s s p p r r o o c c k k e e t t s s t t o o g g e e t t h h e e r r t t o o p p r r e e v v e e n n t t r r a a p p i i d d w w e e a a r r o o f f
t t h h e e s s e e c c o o m m p p o o n n e e n n t t s s . .
N N e e v v e e r r o o p p e e r r a a t t e e t t h h i i s s v v e e h h i i c c l l e e w w i i t t h h t t h h e e d d r r i i v v e e c c h h a a i i n n t t o o o o l l o o o o s s e e o o r r t t o o o o
t t i i g g h h t t a a s s s s e e v v e e r r e e d d a a m m a a g g e e t t o o t t h h e e d d r r i i v v e e c c o o m m p p o o n n e e n n t t s s c c a a n n o o c c c c u u r r . .
MAINTENANCE PROCEDURES
N N O O T T I I C C E E
N N O O T T I I C C E E
129