Table of Contents
Advertisement
+
+
RetCam3 User Manual
Figure 52 Close drawer and replace connections
CAUTION: Only touch the exterior surface of the illumination lamp. Do not touch the
bulb, which is located in the center of the reflector, nor the inner (concave) surface
of the reflector. Skin oils will adhere to the bulb and reflector, which reduces the
cooling efficiency of the bulb and thereby creates a hot-spot leading to premature
burnout. Handle by the outside of the lamp only, as shown.
Key Validation
Note: New RetCam3 systems ship with their license key already registered
and validated. However, significant changes to the system hardware or a
re-load of the system software for any reason (including software upgrade)
may require you to perform the key validation process as described below.
Key validation requires that you get a license key from Clarity to use the
revamped system, and you cannot request this key until after installation is
complete. Since it may take up to two (2) business days to obtain a license
key after submitting a request, we recommend that you effect system or
software upgrades when you can manage two business days without use of
the system.
Note: To ensure the preservation of your patient data and images, we strongly
recommend that you perform a complete backup of the system's images
before you begin any software installation.
Maintenance and Support 65
PN 21-100375 Rev. A
Advertisement
Table of Contents
