Capturing Video; Figure 20 Video And Image Capture Controls - Clarity RetCam 3 User Manual

+
+
+
+
RetCam3 User Manual
Control Panel
Press the button.
Note: Saving video can take significant time and consumes a great deal of
disc space. To maintain optimal system performance, select the images of
interest from the video then delete the video prior to exiting Image Capture.
Note: The storage capacity of the system hard drive is a maximum of
approximately 250,000 still images. Saving a combination of videos and stills
will affect the total number of each that can be saved. Saving images with
annotations reduces the total number of images that can be saved.
Note: If the Control Panel (or keyboard) controls do not respond, check that
the Footswitch Controls are not activated.

Capturing Video

Up to 2 minutes of Video capture is available per session. A progress bar is enabled
each time video is started to let you know the percentage of time used.

Figure 20 Video and image capture controls

Video is captured at full resolution, 30 frames per second.
The following controls are available on screen:
• Record Video—Starts recording video; to stop recording video, select Stop
Recording or Pause Recording.
• Freeze Live—Freeze an image during image capture.
• Switch to FA—Change the image type to Fluorescein Angiography. See
Chapter 6, Fluorescein Angiography
• Start Timer—Start a timer to record the time elapsed during the exam.
• Save
Still—Saves a still image to the hard drive
• Footswitch Operation options:
• Use the button to pause and continue video recording.
Note: The storage capacity of the system hard drive is a maximum of 140
minutes of total video (for example, 70 videos of two minutes duration each,
or 280 videos of 30 seconds each). Saving a combination of videos and stills
Using the RetCam 3 29
Module.
PN 21-100375 Rev. A