Cyw920829B0M2P4Xxi100-Evk Details - Infineon AIROC CYW20829 User Manual

AIROC™ CYW20829: CYW920829B0M2P4XXI100-EVK Module
Evaluation Kit user guide
Introduction
Figure 1 CYW920829M2EVK-02 kit contents
Contact the nearest Infineon sales office for assistance for any missing part in the kit contents:
www.infineon.com/support.
1.2

CYW920829B0M2P4XXI100-EVK details

CYW920829B0M2P4XXI100-EVK with the following features:
1. CYW20829 carrier module with onboard Trace antenna or External Pad
2. Expansion headers compatible with Arduino shields
3. Supports 3.3 V, coin-cell (3 V), and 1.8 V operation of the CYW920829B0M2P4XXI100-EVK device
4. Reset button (black), User button1 (white), and User button2 (white)
5. Onboard Micro-USB connector (J5) for programming and debugging purposes
Follow these steps before connecting the board and verify the driver installation:
1. Ensure that all the jumpers are in the default configuration as shown in
is selected and displays embedded application trace messages.
locations.
2. Default jumper location on EVK is given in
Default jumper configurations on the EVK
Table 1
Jumper ref des
J9
J10
J12
J17
J13
J14
User guide
Table
Jumper description
VBAT voltage selection
VIO_BASE voltage selection
VDDPA voltage selection
VIO_BASE / eFuse(2V5) voltage selection
Peripheral voltage enable
Thermistor enable
Table 2
Figure 2
1.
Default state
1-3
1-3
1-2
1-2
1-2
1-2
7
to Table 7 so that the UART
shows the default jumper
002-39356 Rev. **
2024-02-07