Spi Interface Selection - Infineon AIROC CYW20829 User Manual

AIROC™ CYW20829: CYW920829B0M2P4XXI100-EVK Module
Evaluation Kit user guide
Kit rework
5.3

SPI interface selection

The default SPI lines are not configured in the kit. To enable the SPI option and route to the Arduino shield by
following the rework.
Default P1.0 is connected to USER_BTN2 via R87, remove it and install R104 to use SPI_CS
•
Default P1.1 is connected to USER_LED1 via R90, remove it and install R105 to use SPI_CLK
•
Default P1.3 is connected to SWDCLK via SW6 POS1, change it to POS2 to use SPI_MISO
•
Default P1.2 is connected to SWDIO via SW6 POS1, change it to POS2 to use SPI_MOSI
•
Figure 39 SPI interface selection
User guide 46 002-39356 Rev. **
2024-02-07