AIROC™ CYW20829: CYW920829B0M2P4XXI100-EVK Module
Evaluation Kit user guide
Kit rework
5.4
I2S interface selection
The default I2S lines are not configured in the kit. To enable the I2S interface and route to the Arduino shield by
following the rework.
Default P0.4, P3.2 is connected to RGB LED, UART_RX via R83, R95 remove these and install R84, R96 to use
•
I2S_MCLK
Default P0.5, P3.3 is connected to USER_BTN1, UART_TX via R86, R98 remove these and install R85, R97 to
•
use I2S_TX_SCK
Default P1.0, P1.4 is connected to USER_BTN2, D2 via R87, R91 remove it and install R88, R92 to use
•
I2S_TX_WS
Default P1.1, P1.4 is connected to USER_LED1, USER_BTN2 via R90, R94 remove these and install R89, R93 to
•
use I2S_TX_DATA
User guide
47
002-39356 Rev. **
2024-02-07