Register A C52-Sp Dect Expansion Speakerphone - Snom C620 User Manual

Registration

Register a C52-SP DECT Expansion Speakerphone

You can register up to two C52-SP DECT Expansion Speakerphones to your C620 SIP
Wireless Conference Phone.
If your organization uses DECT auto registration:
The C52-SP will automatically register to the C620. You do not need to take any
further action.
If your organization does NOT use DECT auto registration (or if you are not sure):
You must first turn off auto registration on the C52-SP by performing the
following steps:
1. Press and hold the MUTE ALL button on the C52-SP for five seconds.
2. Press and hold the TALK/OFF button on the C52-SP for five seconds.
The C52-SP LEDs turn steady orange for five seconds, then slowly flash
orange.
At this point, you can manually register the C52-SP to the C620 by folllowing
the instructions below.
Manually register the C52-SP to the C620
1. Press and hold the REGISTRATION button on the bottom of the C52-SP unit for
five seconds.
When you release the button, the C52-SP LEDs will flash red and green
alternatingly. This indicates the C52-SP is ready for registration.
2. Press and hold the LINK key on the C620 base unit for four seconds.
The and
If registration is successful, the LEDs on the C52-SP turn green for five seconds.
SIP
If registration fails, the LEDs on the C52-SP turn red for five seconds.
3. To register an additional C52-SP speakerphone, follow the instructions in
"Register a C52-SP DECT Expansion Speakerphone", above.
SIP
LEDs flash green for about 10 seconds, then turn steady green.
54