Connect Power To The Conference Phone; Register The Conference Phone To The Base - Snom C620 Quick Installation Manual

Connect power to the conference phone

1� Plug the DC 12V 3A round jack end of the power adapter into the power jack on the
back of the charging dock�
2� Plug the large end of the power adapter into a wall outlet not controlled by a
switch�
3� Place the rear connectors of the conference phone into the charging dock�
• The supplied DC 12V 3A round jack power adapter is designed for use only
with the C620 conference phone� It is not designed to power other devices�
Do not connect the supplied DC 12V 3A round jack power adapter to any other
devices�
• The DC 12V 3A round jack power adapter is intended to be correctly oriented in
a vertical or floor mount position� The prongs are not designed to hold the plug
in place if it is plugged into a ceiling, under-the-table, or cabinet outlet�

Register the conference phone to the base

Your conference phone is pre-registered to the base station� If you need to manually
re-register the conference phone, follow these steps:
1� Place the conference phone in the charging dock, and make sure it is connected to
power�
2� If the conference phone is displaying
3� If the conference phone is displaying
4� If the conference phone is displaying
5� If the conference phone is displaying
8
go to step 6�
go to step 7�
go to step 8�
go to step 7�