Temporarily Silencing The Ringer; Putting A Call On Hold - Snom C620 User Manual

Conference phone operation
To end mute of all microphones:
Press MUTE ALL on the conference phone or press
•
The status indicators turn green, and the

Temporarily silencing the ringer

When the conference phone is ringing, you can temporarily silence the ringer without
disconnecting the call. The next call rings normally at the preset volume.
To silence the ringer:
• Press MUTE ALL on the conference phone.
The symbol appears.
NOTE: The conference phone rings when there is an incoming call unless the ringer
volume of the conference phone is turned off.

Putting a call on hold

Use this feature to hold one call while you access another. The phone also puts calls
on hold automatically when you answer another call by pressing the
transfer a call, or create a conference.
During a call, press
From the On hold screen, you can press:
p and q to select a call (if you have a call on hold and another call active or on
•
hold).
t and u to see the different softkeys available.
•
• End to end the call.
New
• to dial a new call.
See "Making a call in idle mode or with call(s) on hold:" on page 17
Resume
• to take the call off hold.
• Transfer to transfer the held call to another party.
See "Transferring calls" on page 21.
• Conf. to start a conference with the held call.
See "To create a conference with a held call:" on page 24
Note that the default On hold screen soft keys are shown above. Your phone's soft
keys are programmable and may differ from what is shown here.
. The On hold screen appears.
symbol disappears.
20
on a wireless mic.
Answer
key,