Registering Wireless C52 Speakerphones - Snom C520-WiMi User Manual

Configuring the Phone

Registering wireless C52 speakerphones

For large meeting rooms, you can extend the range of the C520-WiMi with up to three
wireless DECT Snom C52 Speakerphones. You can use the speakerphone to answer
and end calls and mute the audio on the entire system (i.e., the conference phone and
all connected devices like speakerphones and wireless microphones).
Note: If a DECT headset is already registered, you can register up to two C52
Speakerphones.
Registering the C52 Speakerphone to the C520-WiMi
Note: If a speakerphone is already registered to the phone, you must first
deregister all speakerphones before you can register another or a new one.
1. Put the battery pack in the C52, connect the power adapter, and plug the adapter
into the wall outlet. The LEDs on the C52 flash orange slowly.
2. Press the white registration button underneath the battery compartment for five
about seconds until its LEDs are flashing red and green alternatingly.
3. On the C520-WiMi Conference Phone, press
4. In the Main Menu, press
5. In the User settings menu, press
).
1
6. Press to register the C52 speakerphone.
The screen displays Registering... and then Registration succeeded. The phone
plays a confirmation tone. The registered speaker LEDs stop flashing red and
green. The LEDs turn green briefly and then turn off while the red Power LED turns
on.
7. Repeat steps 1 to 6 for any additional C52 speakerphones.
• If a speakerphone fails to register, the conference phone will display
Registration failed.
• To cancel registration, press
3
(or highlight 3 User settings and press
D E F
6
(or highlight 6 Wireless speaker and press
M NO
.
49
.
).