Camera Link Bit Definitions; Camera Timing - Teledyne Piranha4 Quadlinear User Manual

Piranha4 RGB + NIR / Mono Camera User's Manual

Camera Link Bit Definitions

Signal
CC1
CC2
CC3
CC4
For additional Camera Link documentation refer to the Teledyne DALSA Web site's

Camera Timing

Note: Information on setting up the camera's AOI can be found here, Area of Interest (AOI) Setup.
RGB 8 bit, CL base, maximum line rate 40 kHz, no AOI and 85 MHz CL clock
Line Valid
CL Clock
CL Port A
CL Port B
CL Port C
This timing can be used for applications that require line rates only up to 40 kHz and therefore can use
Camera Link Base mode with only one cable.
The RGB output format is compatible with the Camera Link specification for Base RGB. Line rates up to
70 kHz can be achieved by using the Area of Interest (AOI) feature; where the smaller the AOI, the
greater the potential line rate.
Teledyne DALSA
EXSYNC
Spare
Direction
Spare
Table 6: Camera Control Configuration
Red 1 Red 2 Red 3
D 0 .. D 7 D 0 .. D 7 D 0 .. D 7
Green 1 Green 2 Green 3
D 0 .. D 7 D 0 .. D 7
D 0 .. D 7
Blue 1 Blue 2 Blue 3
D 0 .. D 7 D 0 .. D 7
D 0 .. D 7
Configuration
Red 4 Red 2047
D 0 .. D 7 D 0 .. D 7
Green 4 Green 2047
D 0 .. D 7
D 0 .. D 7
Blue 4 Blue 2047
D 0 .. D 7
D 0 .. D 7
25
application notes.
Red 2048
D 0 .. D 7
Green 2048
D 0 .. D 7
Blue 2048
D 0 .. D 7
03-032-20217-02