Flashforge Adventurer 5M User Manual page 15

Introduction to Auxiliary Functions
Levelling and Calibration
During the first startup, equipment calibration will be performed. During subsequent
use, choose levelling or vibration compensation as needed.
When to perform levelling:
If continuously printing with PLA material, perform automatic levelling once with
•
no need to do so before each print. However, performing levelling can inevitably
improve the printing success rate;
When switching between different materials (e.g., from PLA to ABS), please
•
perform levelling before each print;
If the platform-nozzle distance is too far (poor adhesion) or too close (no filament
•
extrusion), please perform automatic levelling;
After replacing the build plate or nozzle, please perform automatic levelling.
•
When to perform vibration compensation:
When there is noticeable ghosting and ringing on 3D prints;
•
After adjusting the tension of the synchronous belt;
•
When the printer has been unused for a long time and is now being restarted.
•
Instructions:
Click on settings and click on the levelling button to enter the levelling and calibration
interface. Choose [Leveling] or [Vibration test], click [Start], and the printer will
automatically perform the corresponding operation. (Note: Before calibration, ensure
there are no foreign objects on the platform or at the nozzle tip.)
Other Function Settings
In the information interface, you can enable or disable sound and filament detection,
and perform firmware updates.
When [Filament detect] is enabled, the printer will stop printing if filament runs
•
out mid-print.
When connected to a wireless network, click [Firmware update] to view the
•
current version, check for updates, and perform online firmware updates.
15