Flashforge Adventurer 5M User Manual page 18

What to do if the extruder moves but doesn't extrude filament at the beginning of
printing after clicking the model for printing?
Observe the filament guide tube to check if filament has entered the nozzle. If not,
please click [Load] until filament comes out. If that doesn't help, check if the nozzle is
clogged. If so, please refer to the solution of the first question "How to unclog the
nozzle".
What to do if the nozzle position is too high (far from the platform) or too low
(hitting the platform) during printing? How to level it?
Please check if the platform is properly installed and there is no excessive residue on the
nozzle. If these issues exist, address them first. Then, go to the settings interface, select
the levelling option, and perform automatic levelling or enable automatic levelling
before printing.
Can filaments from other brands be used?
Yes. You can use filaments from other brands, but certain parameter adjustments are
required due to slight temperature differences in different filaments.
Is it safe to print with ABS material?
ABS can release toxic gases during heating. If conditions permit, consider printing in a
well-ventilated area. It is recommended to print non-toxic materials such as PLA in
children's activity places.
What to do if the printed model warps or doesn't adhere well?
Method 1: Increasing the platform temperature can improve the adhesion between the
platform and the model.
Method 2: Adding a brim during model slicing can alleviate the issue.
Method 3: Apply glue.
Method 4: Clean the platform to remove any oil or dirt.
Method 5: Check if the platform is level. The levelling and calibration function can be
used.
18