Flashforge Adventurer 5M User Manual page 9

Insert the buckle on the back of the screen into the printer's slot and push the screen
according to the arrow direction to lock it in place.
Unlocking the Build Plate
Note: Please ensure that the platform has been cleared up!
Please use a 2.0mm Allen wrench to remove four screws which lock the build plate (as
indicated by the arrow).
First Print
Power on the printer, turn on the power switch, and wait for the screen to respond.
Following the guide on the screen, select your preferred language. Upon language
selection, click [Next] and the machine will perform the first calibration. Vibrations and
noise during calibration are normal. (Note: Please keep the machine on a stable surface
and do not move it during calibration.)
Load the filament. First, cut off the bent part of the filament end. Hang the filament on
the spool holder. Pass it through the filament sensor until it's seen from the other end
of the filament guide tube. Push it forward to the feed roller, until it cannot go further.
(Please use PLA filament for the first print on initial setup).
9