Flashforge Adventurer 5M User Manual page 10

Click [Load] and select [PLA] for the first print. Wait for the extruder to heat up. Feeding
will begin after heating. Successful filament extrusion from the nozzle indicates
successful loading. Lastly, confirm the filament guide tube is properly inserted.
Note: If no filament is extruded, manually insert the filament into the inlet and click
[Back] to retry. Feel for filament movement until it is extruded.
Please clear the filament residues on the nozzle and platform. Users must apply glue to
the platform so as to improve adhesion for the first print. Click [Print] and the machine
starts printing the built-in file (configured for PLA material).
Software Introduction & Installation
Before printing 3D model files, you need to configure slicing presets for the
corresponding printer. Recommended slicing software: OrcaSlicer / FlashPrint 5
Pre-printing steps:
Obtain the 3D file (STEP/STL/OBJ).
•
Download and install the slicing software.
•
Use the slicing software to convert the file into the machine-readable format.
•
Import the sliced file via a USB flash drive or network transfer to the printer for
•
printing.
10