Advertisement
Step 17
Flip the TURNTABLE (12) and TURNTABLE BOTTOM (N) over.
å
Place the TURNTABLE (12) on the BOTTOM (M), so the large hole in the TURNTABLE BOTTOM (N) lines up with the hole in
å
the TURNTABLE and the hole in the BOTTOM as shown below in diagram 1. Fasten the TURNTABLE to the BOTTOM with a
SILVER 1/2" FLAT HEAD SCREW (17).
Turn the TURNTABLE BOTTOM (N) counterclockwise 90 degrees to fi nd the next hole as shown below in diagram 2.
å
Turn a SILVER 1/2" FLAT HEAD SCREW (17) into this hole.
Turn the TURNTABLE BOTTOM (N) counterclockwise 90 degrees to fi nd the next hole as shown below in diagram 3.
å
Turn a SILVER 1/2" FLAT HEAD SCREW (17) into this hole.
Turn the TURNTABLE BOTTOM (N) counterclockwise 90 degrees to fi nd the next hole as shown below in diagram 4.
å
Turn a SILVER 1/2" FLAT HEAD SCREW (17) into this hole.
SILVER 1/2" FLAT HEAD SCREW
(4 used in this step)
IMPORTANT: Turn all
screws in a few turns
before completely
tightening any of them.
1.
17
2.
N
M
3.
12
4.
Page 21
Advertisement
