Advertisement
Step 9
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the LOWER ENDS (A and B). Use eight SILVER 1/2" FLAT HEAD SCREWS (18).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS. Turn a SCREW into
this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
SILVER 1/2" FLAT HEAD SCREW
(8 used in this step)
Open end
Open end
1
Push up on the black lever and pull the SLIDE from the RAIL.
18
1
B
1
2
Open end
1
1
A
These holes must be here.
Open end
Page 13
Advertisement
