Epilog Laser Fusion Maker Manual page 5

17000 - Y-Axis Bearing Block Replacement
3. Install, but do not fully tighten the four
to seven (4-7) 7/64" Allen screws that
secure the y-axis assembly to the
y-axis guide rail supports through the
circular cutouts under the y-axis guide
rail:
4. Once all of the y-axis guide rail
support screws have been loosely
installed, fully tighten each screw
following the order below:
tooltip
1 3
5
2
7 6 4
5. Connect the y-axis motor harness to
the y-axis motor:
6. Position the y-axis motor into the
y-axis assembly and loop the y-axis
belt around the y-axis drive pulley:
5