Epilog Laser Fusion Maker Manual page 3

17000 - Y-Axis Bearing Block Replacement
7. Loosen and remove the four (4) Phillips
screws that secure the y-axis motor:
8. Remove the y-axis motor from the
y-axis assembly to access the y-axis
motor harness:
9. Remove the y-axis motor harness from
the y-axis motor:
10. The y-axis bearing blocks ride on the
y-axis guide rails in the engraver which
are secured to the y-axis guide rail
supports:
11. Loosen and remove the four to seven
(4-7) 7/64" Allen screws that secure the
y-axis assembly to the y-axis guide rail
supports through the circular cutouts
under the y-axis guide rail:
The y-axis guide rail supports are
calibrated and shimmed at the factory to
be parallel with each other. Do not re-
move the y-axis guide rail
supports.
3