Epilog Laser Fusion Maker Manual page 5

17000 - Z-Belt Replacement
6. Connect the z-axis motor electrical
harness.
7. Begin to tighten the z-axis motor
tensioner thumbscrew to tension the
z-axis belt:
8. Continue to tighten the tensioner
thumbscrew until the motor bracket is in
line with the mark made in the removal
procedure:
9. Install the front access panel and the
crumb tray of the engraver:
10. Install the right panel of the engraver:
11. Connect the engraver from power.
If further assistance is required, please
contact Epilog Laser Technical Support by
phone at 303-215-9171, or by email at
tech@epiloglaser.com.
5