Epilog Laser Fusion Maker Manual page 3

17000 - Z-Belt Replacement
8. Loosen and remove the four (4) 5/32"
Allen screws on the z-axis motor mount:
9. Remove the z-axis motor assembly:
10. Press the z-axis belt flat against the
bottom of the engraver chassis and slip
the belt underneath each lead screw
pulley.:
1. Once the z-axis belt has been slipped
under each lead screw pulley, remove
the belt from the engraver.
Z-Axis Belt Installation
1. Place the z-axis belt in the bottom of
the engraver.
2. Press the z-axis belt flat against the
bottom of the engraver chassis and
slip the belt underneath each lead
screw pulley. Ensure that the toothed
side of the belt wraps around each
lead screw pulley:
3. Repeat this process for all four (4) lead
screw assemblies in the engraver,
using the images below as a reference
for proper x-axis belt routing:
24 x 12 Table
3